balancing error
英 [ˈbælənsɪŋ ˈerə(r)]
美 [ˈbælənsɪŋ ˈerər]
均衡误差；剩余误差
双语例句
- They could also simulate traffic loads to discover what will happen during load balancing, error handling, and so forth.
它们还可以模拟通信负载，从而发现在负载平衡、错误处理，等等过程中会发生什么。 - Vibration equation of two-plane balancing rotor is derived. Non-linear error of bearing support of hard bearing balancing machine is analysed and relation curve is presented.
推导了双面平衡转子的振动方程，分析了硬支承动平衡机的支架非线性误差对振动幅值与相位的影响，并绘制了关系曲线。 - It has shown that the balancing parameters in AC bridge can be obtained by means of the Fourier coefficients of the error voltage, which is produced by arbitrarily adjusting the bridge two times, i. e.
论证表明，通过对电桥的可调参数任意调节两次，由两次调节所形成的误差电压的傅里叶系数即可完全确定电桥平衡的参数，得到被测阻抗Zx的值。 - Calculation on the balancing time of mechanical railway track scale lever system and Study on the error in its weighing in motion
机械轨道衡杠杆系平衡时间的计算及其动态称量误差的探讨 - Finally, the fundamental principles of the conventional balancing machines are given and causes of grave error which may be produced during balancing process are analysed.
本文亦简要分析了旋转机械平衡机床的基本原理以及在平衡过程中可能导致较大误差的因素。 - Based on the heat balancing calculation, the paper compares the difference of there models, the result indicates that the two models of the heat balancing and the equivalent enthalpy drop integral are the same, and the equivalent enthalpy drop local calculation exists acceptable error;
以热平衡模型为基准，比较了3种算法模型的差异，计算结果表明：热平衡计算和等效焓降整体计算在本质上是一致的，而等效焓降局部计算存在可以接受的误差； - Finally, the paper raised a relatively complete error analysis method, through the analysis of on-site dynamic balancing which combined with engineering practice method, it proved the proper methods of checking the error, and the balance reached to the ideal effect.
最后，提出了较完整的现场动平衡误差分析方法，结合工程实例对现场动平衡影响系数法应用过程中所产生的误差进行分析，经实际验证误差分析正确，平衡达到理想效果。 - Load balancing in this study were presented first, and then the overview in load balancing of the current domestic and international status in human error research was made.
本研究首先对载重平衡作了介绍，然后综述了当前国内外载重平衡人误研究的现状。 - Some measures of vibration reduction and load distribution balancing are conducted, such as floating of components and planet run-out error phasing.
深入地研究了部分减振及均载措施：中心构件浮动及行星轮偏心相位调谐等。